Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 278)

User’s Manual – GPS Mode
268
• NTRIP
Rover
: Select this mode to use the receiver as an RTK
rover where the base corrections are to be supplied to the
rover by connection to an NTRIP service (see page 225). To
configure an NTRIP rover, you must setup the Windows
Networking modem parameters on the Data Modem card (see
below).
Note: You do not need to select the RTK Correction Format for an
NTRIP rover because this will be determined by the NTRIP service
you pick at rover setup time.
• Post
Processing
: Select this mode to use the receiver to log
data for post processing. You can do either static or kinematic
(stop and go) post processing data collection control with
Survey Pro. You do not need to setup the data link
parameters for post processing receivers.
o
Select the RTK Correction Format if this is
required
o
Select any Rover Options if this is required
o
Select whether or not to use a CMR station index
for base or rover setup if this is required.
o
Set the elevation cutoff desired for data collection.
This is the angle below which satellites will not be
used.
Receiver Settings – Data Modem
1. Select the specific type of data link in the Data Modem drop down
list.
2. Configure any settings required for this modem
Note: There are many different Data Modem types available. The
content of this drop down list will depend on the brand and model of
receiver selected. The settings to configure on this page will depend
on the specific Data Modem selected. If you are using a device that is
not listed in the Data Modem drop down, then you can choose to use