Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 82)

User’s Manual – Conventional Mode
72
Stakeout Example
When setting up to perform stakeout, the requirements are nearly
the same as with data collection. You need an existing occupy point,
backsight point or direction, and a foresight. The main difference is
existing points are being located during stakeout rather than new
points being collected.
In the example below, all of the steps required to perform a simple
point staking job are explained from the initial setup to the staking
itself. For consistency, this example assumes you are running Survey
Pro in Manual Mode so the shot data will need to be input from the
keypad. The software behaves differently in Manual Mode compared
to when using a total station. The differences are noted where
applicable.
For this example we will use the job that was created with the
Traverse / Side Shot Example, above. When staking the first point,
we will take two shots to the prism to “home-in” on the design point.
When staking the second point, we will only take one shot combined
with the Store/Tape routine to store the stake point.
Set Up
1. Open the job that was created in the Traverse / Side Shot
example.
a. From the Main Menu, select File , Open / New to open the
Open / New screen.