Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 78)

User’s Manual – Conventional Mode
68
i. Tap to exit from the Backsight Solved screen.
The map view will open showing your current
setup.
j. Tap (Close) to continue.
Performing a Side Shot
5. Access the Survey , Traverse / Sideshot screen and
fill in the appropriate fields. The backsight
information is displayed in the lower portion of the
screen. At this point, it is assumed that your total
station is over the occupy point and its horizontal
angle was zeroed while aiming toward the backsight.
a. In the Traverse / Sideshot screen, enter the
following data:
Foresight: 3
Description: SS
HR: 5
These values will define the point name,
description, and rod height for the next point
that is stored.
b. Assuming that the total station is aiming toward
the prism, which is located over the foresight, tap Side Shot .
When connected to an instrument, this would trigger the total
station to take a shot, compute coordinates for the new point
and store it. Since we are running in Manual Mode, we will
enter the shot data from the keypad.
c. Enter the following data:
Angle Right: 70
Zenith: 90
Slope Dist: 100 and then tap (OK). The new point is