Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 286)

User’s Manual – GPS Mode
276
Base Setup Two - GET and SET
The Base Setup GET and SET screen is used when the geodetic
coordinate of the base reference position is not known. In this case,
you must GET an autonomous position from the GPS receiver and
then you can SET this as the reference position.
7. Tap GET Position From Rx to get an autonomous
position from the receiver. If you wish to get an
averaged position, enter a number in Average
position [n] epochs before GET
.
8. If you are not post processing, leave the Post
Processing Recording Interval
field set to Off. If you
are post processing, select the desired recording
interval in this field. The receiver will open a file
(with the next available default name), start
recording GPS raw data, and record the station and
antenna information for this static session.
9. Check the results displayed in the edit boxes. If it
looks good, tap SET to start the base receiver
broadcasting this reference position and GPS
observations over the radio link, and to configure the base
reference position in Survey Pro.
Start GPS Survey – Rover Setup
The Start GPS Survey Rover Setup screen is used to setup an RTK
rover receiver, and to configure or check the base point reference
position in Survey Pro. Before proceeding to the Rover Setup screen,
you will be prompted to connect to an RTK rover or an NTRIP rover
receiver. Connecting to a rover receiver uses the same screen used for
the base receiver, described above on page 273. If you select an RTK
rover receiver, you will proceed directly to the Rover Setup screen. If
you choose an NTRIP rover, you will first be prompted to choose an
NTRIP service before you proceed to the Rover Setup screen