Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 314)

User’s Manual – GPS Mode
304
5. Enter the direction (azimuth/bearing) from the reference point to
the offset point. You can enter a direction in one of the following
ways:
• Using the horizontal angle returned from the conventional
instrument if you took a shot.
• Occupying a point on line with the reference point and the
offset point. After you occupy the reference point, tap
Direction from Two Points and then occupy a point on line with
the reference point and the offset point. When you are done
occupying the on line point, you will be prompted for the
direction to your offset point.
• Entering a value by hand, such as when you measure the
offset direction with a compass.
6. Tap Store to store the offset point.
7. Store any number of additional offset points from this GPS
reference point. The shot data for each point is recorded in .RAW
data. Tap Close when you are done storing points.
Feature Collection
Use this method if you want to continuously collect multiple points
using either a measurement interval or by manually accepting each
point. You can select from six different data collection modes.
1. Go to the Survey > Data Collection screen.
2. Enter a point name in the Point field. If this point already exists,
you will be prompted to overwrite or choose the next available
point.
Note: If you have Store GPS Raw Data set to + Bl,CV or + Bl,CV + Rx
Raw,
feature collection will not store base line records because there
is no discrete site occupation of each point. Therefore, the point name
does not need to be a valid Site Id.
3. Enter a Description.