Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 280)

User’s Manual – GPS Mode
270
Start GPS Survey
The Start GPS Survey wizard is used to start any RTK survey. This
wizard will guide you through the steps required to choose a
coordinate system, set up your equipment, solve an adjustment, and
start collecting data or staking out points. The Start GPS Survey
wizard can be used for any RTK setup, regardless of your coordinate
system requirements, and your base and rover equipment
configuration.
The steps required to complete the Start GPS Survey wizard will
depend on the coordinate system and equipment you are using. All
the possible steps are described below.
Start GPS Survey – Choose One
Point Setup
One point setup is a special case of the Start GPS Survey
wizard. You can use one point setup mode only when you
have a brand new job with only one point. When you use
one point setup, Survey Pro will use Ground - TDS
Localization
mode, and automatically solve the
localization adjustment to give you ground level
coordinate system with the origin at your first point.
When you choose one point setup, there are no additional
steps required to solve your coordinate system, all you
have to do is complete base and rover equipment setup
and you are ready to survey.