beautypg.com

Rtk settings, Post processing settings, Receiver settings – general – Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual User Manual

Page 279

background image

GPS Module

269

the ‘Generic Serial’ device and simply set the correct port, baud rate,
and parity for this device.

Receiver Settings – General

The controls on the Receiver Settings – General card will vary
depending on brand and model. Please see the documentation that

came with your GPS receiver for details on the different settings that

may be available. If using a Bluetooth GPS receiver, refer to the
Bluetooth section on Page 316.

RTK Settings

If you are using Survey Pro for RTK, or RTK simultaneous with post
processing data collection, the following cards of the Job > Settings

screen are used:
Measure Mode: is where you select the type of GPS raw data to store
for each point. You can also set measurement acceptance criteria.

These settings are described in detail in the Reference Manual.

Post Processing Settings

If you are using Survey Pro for RTK simultaneous with post
processing, or post processing data collection, the Post Process card of

the Job > Settings screen applies.
You can specify how to deal with autonomous positions and select a
special layer to store autonomous points on. These settings are

described in detail in the Reference Manual.