Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 324)

User’s Manual – GPS Mode
314
Adjust with Projection – Prompt Adjust
The Adjust with Projection Prompt Adjust screen is only shown when
the wizard opens automatically when you change the coordinate
system. This will be the case when you select a zone or site using the
Select Coordinate System screen, when you change or remove the
geoid using the Select Coordinate System screen, or when you change
the horizontal projection mode on the Survey > Projection screen.
The Prompt Adjust screen describes the difference between the two
coordinate systems, and gives you the option to adjust or to not adjust
the job.
1. Choose to Adjust job with new projection or Do not adjust job.
• If you pick Do not adjust job, then the Next>
button is hidden and the Done button shows.
Tap Done to update the coordinate system but
not change any job file points.
• If you choose to Adjust job with new projection, you
may have the choice to Adjust all points or to
Adjust only points with geodetic coordinates
. These
two cases are described in the Select Points
section. The criterion used to determine if this
choice is allowed is based on the nature of the
change between the current and the new
coordinate system. This may be different for the
horizontal and vertical dimension. The title of
the box will indicate the dimension considered
for this setting.
2. Tap Next> to open the Preview screen.
Adjust with Projection – Results
The Adjust with Projection Results screen is used to preview the
results of the adjustment before anything is applied to the job file.
The default view is to list the action and results only for points that
will be updated in the adjustment. You can tap Show all points to
update the list to show the reason unchanged points are not adjusted.