Performing a traverse adjustment – Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual User Manual
Page 204

User’s Manual – Conventional Mode
194
Performing a Traverse Adjustment
1. Tap Adjust , Traverse Adjust from the Main Menu.
2. Use the Tap Polylines… or To/From… button to select
the polyline or points that define your traverse,
which should be in the same order that the traverse
points were collected.
3. Select the appropriate checkboxes to define the type
of adjustment(s) to perform and what will be
adjusted.
4. Tap Next > to continue to the next screen. The
screen that opens will depend on the selections made
from the main screen.
5. If an angle adjustment is being performed, the
screen shown here will open. Enter the closing angle
for the traverse in the form of an angle-right.
6. Tap Next > to open the next screen of the
adjustment wizard.