Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 319)

GPS Module
309
autonomous layer. If you choose to store the point in the Receiver
file only,
the Site ID can be any valid name for the receiver and you
are not prompted for layer or attributes.
2. Enter a Description for this point.
Note: If the Site ID or Description is not valid for your model of
receiver, you will be prompted to modify them.
3. Tap Set HR to select an antenna type and enter the slant or
vertical measurement.
4. Tap Apply to send the current station and antenna information to
the receiver. This button may be renamed or disabled depending
on the receiver model.
5. Tap End Survey when you are finished recording data. This closes
the current recording session and file on the receiver. If using a
receiver that supports file downloads, a prompt will open asking if
you want to download the file to the data collector.
Stop & Go Data Collection
1. Choose if you wish to store point in: Receiver and job file or the
Receiver file only
. If you choose to store the point in Receiver and
job file,
then the Point must be a unique point name in the Survey
Pro job and you will be prompted to put the point on the
autonomous layer. If you choose to store the point in the Receiver
file only,
the Site ID can be any valid name for the receiver and you
are not prompted for layer or attributes.
2. Enter a Description for this point.
Note: If the Site ID or Description is not valid for your model of
receiver, you will be prompted to modify them.
3. Tap Set HR to select an antenna type and enter the slant or
vertical measurement.
4. Enter a Duration for this session. If you enter 0 or if you check Log
Until Stop
, the session will continue until you tap Stop.