Start survey – connect to base and rover, Set up base – Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual User Manual
Page 350

User’s Manual – GPS Mode
340
Start Survey – Connect to Base and
Rover
Set Up Base
1. On initial connection to the base, the base
position is recorded until we get a stable average
of 10 epochs. Once we have an average
autonomous base position, follow the instructions
on the screen by entering an antenna height. If
you plan to do post processing data collection in
the base receiver, select a recording interval,
otherwise leave it set to Off and tap Next >.
2. Once the base autonomous position is known, the
job file is searched for a matching point. Any
possible matches are considered eligible base
points. The Setup Base Point screen will be in
one of three states:
No matching base found
One matching base found More than one matching base found