Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 287)

GPS Module
277
Rover Setup – Select NTRIP Service
1. Select a service from the Select an NTRIP service list
box.
2. If this service requires a user name and/or password,
enter these values in the User Name and/or Password
edit fields.
3. If you wish to persist this user name and/or
password, check the Save User Name and Password
box.
4. Tap Connect> to log onto the RTK network server
and use the selected service.
Rover Setup – Set Rover
1. Tap Setup HR to select your antenna type and
measure the slant or vertical height of the antenna.
2. If you are not post processing, leave the Post
Processing Recording Interval
field set to Off. If you
are post processing, select the desired recording
interval in this field. The receiver will open a file
(with the next available default name), start
recording GPS raw data, and record the station and
antenna information for this static session.
3. Tap SET Rover to setup the receiver as an RTK rover.
The rover will then wait to receive the base reference
position over the data modem link. If you have
already configured the base with this data collector,
then the base reference position from Survey Pro will
be checked against the position received at the rover.
If you have not yet configured the base reference position in
Survey Pro, it will be configured with the position received at the
rover.