Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 14)

User’s Manual
4
Survey Pro Installation
Survey Pro is installed from the Installation CD running on a PC. It
will load Survey Pro and then install it on the data collector with the
next ActiveSync connection.
1. Turn on the data collector and connect it to your PC. If you are
using ActiveSync it will attempt to make a connection.
2. With an ActiveSync connection, you will be asked if you want
to install TDS Survey Pro. Answering YES will install the
application on the data collector. An installation routine will
also run on the data collector to complete the process.
Registering
After Survey Pro is installed, the Standard Module must
be registered for Survey Pro to be fully functional. If it is
not registered, Survey Pro will only run in demo mode,
which means all jobs will be limited to no more than 25
points, and if a job is stored on the data collector that
exceeds this limit, it cannot be opened.
If you start Survey Pro and the standard module has not
yet been registered, the screen shown here will open. Tap
the Register Modules… button to access the Register
Modules screen. To run in demo mode, simply tap
Run In Demo Mode .
To register your Modules, tap the Enter Registration
Code button.