beautypg.com

Base setup two – set – Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual User Manual

Page 285

background image

GPS Module

275

4. Tap Next>.

The final step of the Base Setup wizard will depend on the base point
chosen. If the base (lat, lng, ht) is known or can be computed, the

final step is to SET the base at the known geodetic position. If the

base (lat, lng, ht) is not known, the final step is to GET an
autonomous position to SET the base with.

Base Setup Two – SET

The Base Setup Set screen is used when the geodetic coordinate of the

chosen base reference point is known or can be calculated.

5. If you are not post processing, leave the Post

Processing Recording Interval

field set to Off. If you

are post processing, select the desired recording
interval in this field. The receiver will open a file

(with the next available default name), start

recording GPS raw data, and record the station and
antenna information for this static session.

6. Tap SET to start the base receiver broadcasting this

reference position and GPS observations over the

radio link, and to configure the base reference

position in Survey Pro.