Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual User Manual
Page 83
Conventional Fieldwork
73
b. Tap the file name that was created earlier listed
in the Open Recent Job list and then tap
.
Open .
The coordinates for that job are shown here.
2. Set the job settings. (Only the settings that affect
this example are covered here.)
a. Select Job , Settings from the Main Menu.
b. Tap the Instrument tab if it is not already selected
and make sure the Manual Mode profile is
activated. If the symbol is not shown next to it,
select Manual Mode and tap Activate .
c. Tap the Surveying tab and confirm that all of the
checkboxes are unchecked.
d. Tap the Stakeout tab and make sure the Cut
Sheet Offset Stored field is set to Actual Offset.
Note: When performing stakeout, you have the option of
storing cut sheet information. This information is stored
in the raw data file, and when using software on a PC,
such as Survey Link, it can be extracted to create a cut
sheet report.
e. Tap to save the job settings.
3. Setup your backsight. In this example, we will setup on Point 1
and backsight an object where it is assumed that the direction to
that object is known. When connected to a total station, you
would setup over your occupy point and aim toward the backsight
before continuing.