Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 90)

78 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Configuring Multicast Source Discovery Protocol (MSDP)
1
Notifications Received The number of notification messages the MSDP device has received
from the peer.
Source-Active Sent The number of source active messages the MSDP device has sent to the
peer.
Source-Active Received The number of source active messages the MSDP device has received
from the peer.
Last Connection Reset Reason The reason the previous session with this neighbor ended.
Notification Message Error Code
Received The MSDP device has received a notification message from the neighbor
that contains an error code corresponding to one of the following errors.
Some errors have subcodes that clarify the reason for the error. Where
applicable, the subcode messages are listed underneath the error code
messages:
•
1 – Message Header Error
•
2 – SA-Request Error
•
3 – SA-Message or SA-Response Error
•
4 – Hold Timer Expired
•
5 – Finite State Machine Error
•
6 – Notification
•
7 – Cease
For information about these errors, refer to section 17 in the Internet
draft describing MSDP, “draft-ietf-msdp-spec”.
Notification Message Error SubCode
Received See above.
Notification Message Error Code
Transmitted The error message corresponding to the error code in the NOTIFICATION
message this MSDP router sent to the neighbor. See the description for
the Notification Message Error Code Received field for a list of possible
codes.
Notification Message Error SubCode
Transmitted See above.
TCP Statistics
TABLE 22 MSDP peer information (Continued)
This field... Displays...