Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 186)

174 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
IPv6 PIM Sparse
2
L2Reg Sets the flag to 1, if the source is directly connected to the router, or else sets the flag
to 0.
RegSupp Sets the flag to 1, if the register suppression timer is running, or else sets the flag to 0.
RegProbe Sets the flag to 1, if the mcache entry is entering the register probing period, or else
sets the flag to 0.
LSrc Sets the flag to 1, if the source is in a directly-connected interface, or else sets the flag
to 0.
LRcv Sets the flag to 1, if the receiver is directly connected to the router, or else sets the flag
to 0.
RP Show the IP address of the RP.
num_oifs Show the count of the outgoing interfaces.
inherited_oifs Shows the PIM Sparse mode inherited outgoing interfaces.
blocked_oifs Show the PIM Sparse mode blocked outgoing interfaces.
immediate_oifs Shows the local immediate outgoing interface of the mcache entry.
Flags Show the flags associated with the forward entry.
slow ports ethe Shows the forwarding port ID of the mcache entry which is in the software forwarding
path.
L3 Show whether the traffic is switched or routed out of the interface.
(HW) Show whether the entry is software forwarded or hardware forwarded.
sm Sets the flag to 1, if the Sparse Mode entry is enabled and 0, if the PIM dense mode
entry is enabled.
ssm Sets the flag to 1, if the SSM mode entry is enabled, or else sets the flag to 0.
hw Sets the flag to 1, if the candidate for hardware forwarding is enabled, or else sets the
flag to 0.
fast Sets the flag to 1, if the resources are allocated for hardware forwarding, or else sets
the flag to 0.
slow Sets the flag to 1, if the entry is not a candidate for hardware forwarding or the
resource allocation is failed, or else sets the flag to 0.
leaf Sets the flag to 1, if DVMRP is enabled, or else sets the flag to 0.
prun Sets the flag to 1, if PIM is enabled, or else sets the flag to 0.
tag Sets the flag to 1, if there is a need for allocating entries from the replication table, or
else sets the flag to 0.
needRte Sets the flag to 1, if there is no route to the source and RP is available, or else sets the
flag to 0.
msdp_adv Sets the flag to 1, if RP is responsible for the source and must be advertised to its
peers.
AgeSltMsk Shows the slot number on which MP expects ingress traffic.
FID Shows the FID resource allocated for a particular entry.
MVID Shows the MVID resource allocated for a particular entry.
RegPkt Shows the number of PIM register packet received.
TABLE 40 Output parameters of the show ipv6 pim vrf mcache command (Continued)
Field Description