Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 67)

Multi-Service IronWare Multicast Configuration Guide 55
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
Displaying BSR information
To display BSR information, enter the following command at any CLI level.
Brocade(config)# show ip pim bsr
PIMv2 Bootstrap information for Vrf Instance : default-vrf
------------------------------------------------------------------------------
This system is the Elected BSR
BSR address: 1.51.51.1. Hash Mask Length 32. Priority 255.
Next bootstrap message in 00:01:00
Configuration:
Candidate loopback 2 (Address 1.51.51.1). Hash Mask Length 32. Priority 255.
Next Candidate-RP-advertisment in 00:01:00
RP: 1.51.51.1
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60
c(config)#
This example shows information displayed on a device that has been elected as the BSR. The next
example shows information displayed on a device that is not the BSR. Notice that some fields
shown in the example above do not appear in the example below.
Brocade(config)#show ip pim bsr
PIMv2 Bootstrap information for Vrf Instance : default-vrf
----------------------------------------------------------------------------
BSR address: 1.51.51.1. Hash Mask Length 32. Priority 255.
Next Candidate-RP-advertisment in 00:00:30
RP: 1.51.51.3
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60
Brocade(config)#
Syntax: show ip pim [vrf vrf-name] bsr
The vrf option allows you to display BSR information for the VRF instance identified by the vrf-name
variable.
Table 10 describes the output from this command.
Group The multicast group address
Ports The device ports connected to the receivers of the groups.
TABLE 9 Output from the show ip pim vrf group command (Continued)
This field... Displays...