Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 81)

Multi-Service IronWare Multicast Configuration Guide 69
53-1003032-02
Configuring Multicast Source Discovery Protocol (MSDP)
1
S_G_AGEOUT : 0 WRONG_IF : 378153
ABOVE_THRESHOLD : 255 MCAST_FIRST_DATA : 765
MP to LP IPCs:
INIT : 2317 INSERT_VPORT : 4465
DELETE_VPORT : 255 DELETE_VIF : 255
MOVE_VPORT : 0 DEL_ENTRY : 510
INSERT_SOURCE : 0 DELETE_SOURCE : 0
RESET_SRC_LIST : 0 MOVE_TNNL_PORT : 0
AGE_RESET : 94924 FLAG_CHANGE : 741
OIF_FLAG_CHANGE : 741
Error Counters:
RPSET_MAXED : 0
Brocade(config)#
Syntax: show ip pim [vrf vrf-name] counter
Table 20 describes the output from this command.
NOTE
Since VLANs are not VRF-aware, any changes to default-vlan or tagged port moves is counted by all
VRFs in existence at the time, including the default VRF.
Configuring Multicast Source Discovery Protocol (MSDP)
The Multicast Source Discovery Protocol (MSDP) is used by Protocol Independent Multicast (PIM)
Sparse devices to exchange source information across PIM Sparse domains. Devices running
MSDP can discover PIM Sparse sources in other PIM Sparse domains.
Figure 9 shows an example of some PIM Sparse domains. For simplicity, this example shows one
Designated Router (DR), one group source, and one receiver for the group. Only one PIM Sparse
device within each domain needs to run MSDP.
FIGURE 9 PIM Sparse domains joined by MSDP devices
TABLE 20 Output from the show ip pim vrf counter command
This field... Displays...
DFTVlanChange The number of default-vlan-id changes that have occurred since the
applicable VRF was created.
VlanPort The number of times that a tagged port was placed in a VLAN since the
applicable VRF was created.