Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 110)

98 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Configuring DVMRP
1
• DVMRP neighbor information
• DVMRP active prune information
• Available multicast resources
• IP multicast route information
• Active multicast traffic information
Displaying DVMRP group information
To display DVMRP group information, enter the following command.
Brocade# show ip dvmrp group
Total number of groups: 2
1 Group 225.1.1.1 Ports
Group member at e2/3: v30
2 Group 226.1.1.1 Ports
Group member at e2/4: v40
Syntax: show ip dvmrp [vrf vrf-name] group
The vrf option allows you to display DVMRP group information for the VRF instance identified by the
vrf-name variable.
The display shows the following information.
Clearing the DVMRP group membership table
To clear the DVMRP group membership table, enter the following command.
Brocade# clear ip dvmrp cache
Syntax: clear ip dvmrp [vrf vrf-name] cache
This command clears the DVMRP membership for the default router instance or for a specified VRF.
Use the vrf option to clear the traffic information for a VRF instance specified by the vrf-name
variable.
Displaying DVMRP interface information
To display DVMRP Interface information, enter the following command.
Brocade# show ip dvmrp interface
Interface e5/2
TTL Threshold: 1, Enabled, Querier
Local Address: 172.5.1.1
DR: itself
Neighbor:
172.5.1.2
This field... Displays...
Total Number of Groups The total number of DVMRP groups in the network.
Group The DVMRP group address.
Ports The Brocade device ports connected to receivers of the groups.