Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 161)

Multi-Service IronWare Multicast Configuration Guide 149
53-1003032-02
rpf shortcut
1
rpf shortcut
to enable RPF shortcut for LSP paths.
Syntax [no] rpf shortcut
Parameters slot/port Specifies the port that you want to display rpf shortcuts for.
Command
Modes
User EXEC mode
Privileged EXEC mode
Usage
Guidelines
If RPF lookup results in the LSP path, then another lookup is done to get the underlying native route
and that route's next-hop is used as the RPF.
Brocade(config)# router pim
Brocade(config-pim-router)# rpf shortcut
If this feature is disabled, configuration will be removed from multicast and if the native route
changes then the RPF for the multicast cache entries would change. Further, RPF lookup after
using this command will result in the underlying native route from not being used in the LSP path
resolution.
History
Release Command History
Multi-Service IronWare R05.5.00 This command was modified to rpf shortcut for
LSP paths information.