Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 123)

Multi-Service IronWare Multicast Configuration Guide 111
53-1003032-02
IGMP V3
1
Brocade(config)# interface ve 3
Brocade(config-vif-3)# ip igmp version 2
Brocade(config-vif-3)# ip igmp port-version 3 e1/3 to e1/7 e2/9
In this example, the second line sets IGMP V2 on virtual routing interface 3. However, the third line
set IGMP V3 on ports 1/3 through 1/7 and port e2/9. All other ports in this virtual routing interface
are configured with IGMP V2.
Syntax: [no] ip igmp port-version version-number ethernet port-number
Enter 1, 2, or 3 for version-number. IGMP V2 is the default version.
The ethernet port-number parameter specifies which physical port within a virtual routing interface
is being configured.
Enabling membership tracking and fast leave
NOTE
The IGMP V3 fast leave feature is supported in include mode, but does not work in the exclude mode.
IGMP V3 provides membership tracking and fast leave of clients. In IGMP V2, only one client on an
interface needs to respond to a router’s queries; therefore, some of the clients may be invisible to
the router, making it impossible for the switch to track the membership of all clients in a group.
Also, when a client leaves the group, the switch sends group specific queries to the interface to see
if other clients on that interface need the data stream of the client who is leaving. If no client
responds, the switch waits three seconds before it stops the traffic.
IGMP V3 contains the tracking and fast leave feature that you enable on virtual routing interfaces.
Once enabled, all physical ports on that virtual routing interface will have the feature enabled.
IGMP V3 requires all clients to respond to general and group specific queries so that all clients on
an interface can be tracked. Fast leave allows clients to leave the group without the three second
waiting period, if the following conditions are met:
• If the interface, to which the client belongs, has IGMP V3 clients only. Therefore, all physical
ports on a virtual routing interface must have IGMP V3 enabled and no IGMP V1 or V2 clients
can be on the interface. (Although IGMP V3 can handle V1 and V2 clients, these two clients
cannot be on the interface in order for fast leave to take effect.)
• No other client on the interface is receiving traffic from the group to which the client belongs.
Every group on the physical interface of a virtual routing interface keeps its own tracking
record. It can track by (source, group).
For example, two clients (Client A and Client B) belong to group1 but each is receiving traffic
streams from different sources. Client A receives a stream from (source_1, group1) and Client B
receives it from (source_2, group1). Now, if Client B leaves, the traffic stream (source_2, group1)
will be stopped immediately. The show ip igmp group tracking command displays that clients in a
group that are being tracked.
If a client sends a leave message, the client is immediately removed from the group. If a client does
not send a report during the specified group membership time (the default is 140 seconds), that
client is removed from the tracking list.
To enable the tracking and fast leave feature, enter commands such as the following.
Brocade(config)# interface ve 13
Brocade(config-vif-13)# ip igmp tracking
Syntax: [no] ip igmp tracking