Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 160)

148 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
show ip|ipv6 pim interface
1
show ip|ipv6 pim interface
This command displays the neighbor routers on an interface.
Syntax show ip|ipv6 pim interface
Parameters Shows total number of interface to prevent the sender host to become a PIM
neighbor on that interface.
Command
Output
The show ip pim interface command displays the following information:
--------+--------+---+--+------------+---+---------+-------+----+----+-------+
Interface|Local |Ver|St|Router |TTL|Multicast| Filter|VRF | DR |Override
|Address| | |Address Port|Thr|Boundary | ACL | |Prio|Interval
--------+--------+---+--+------------+---+---------+-------+----+----+-------+
e1/3 3.3.3.1 DMv2 Ena Itself 1 None 10 default 1 3000ms
e1/2 2.2.2.1 DMv2 Ena 2.2.2.2 1/2 1 None None default 1 3000ms
Total Number of Interfaces: 2
History
Release Command History
Multi-Service IronWare R05.5.00 This command was modifed to display neighbor
routers on an interface.