beautypg.com

Setting the maximum response time, Displaying igmpv3 information – Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) User Manual

Page 125

background image

Multi-Service IronWare Multicast Configuration Guide

113

53-1003032-02

IGMP V3

1

Setting the maximum response time

The maximum response time defines the maximum number of seconds that a client can wait
before it replies to the query sent by the router. Possible values are 1 – 25. The default is 10.

To change the IGMP maximum response time, enter a command such as the following at the global
CONFIG level of the CLI.

Brocade(config)# ip igmp max-response-time 8

Syntax: [no] ip igmp max-response-time num

The num parameter specifies the maximum number of seconds for the response time. Enter a
value from 1 – 25. The default is 10.

Displaying IGMPv3 information

The sections below present the show commands available for IGMP V3.

Displaying IGMP group status
You can display the status of all IGMP multicast groups on a device by entering the following
command.

To display the status of one IGMP multicast group, enter a command such as the following.

Brocade# show ip igmp group

Total 2 entries

-----------------------------------------------------

Idx Group Address Port Intf Mode Timer Srcs

---+----------------+------+------+-------+-----+----

1 232.0.0.1 e6/2 v30 include 0 7

2 226.0.0.1 e6/2 v30 exclude 240 2

e6/3 e6/3 include 0 3

Total number of groups 2

Brocade# show ip igmp group 239.0.0.1 detail

Total 2 entries

-----------------------------------------------------

Idx Group Address Port Intf Mode Timer Srcs

---+----------------+------+------+-------+-----+----

1 226.0.0.1 e6/2 v30 exclude 218 2

S: 40.40.40.12

S: 40.40.40.11

S: 40.40.40.10

S: 40.40.40.2 (Age: 218)

S: 40.40.40.3 (Age: 218)

226.0.0.1 e6/3 e6/3 include 0 3

S: 30.30.30.3 (Age: 165)

S: 30.30.30.2 (Age: 165)

S: 30.30.30.1 (Age: 165)