Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 152)

140 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
IP multicast traffic reduction
1
Syntax: show ip multicast vlan vlan-id
To display detailed IP multicast traffic reduction information for a specified VPLS instance on the
Brocade devices, enter the following command at any level of the CLI:
Brocade#show ip multicast vpls 10
----+-----+---------+---------------+-----+-----+------
VPLS State Mode Active Time (*, G) (S, G)
Querier Query Count Count
----+-----+---------+---------------+-----+-----+----------
10 Ena Active Self 55 1 1
----+-----+---------+---------------+-----+-----+----------
Router ports: TNNL peer 2.2.2.1 (20s) VC Label 983055 R Label 1034 ,
PIM NBR 120.120.120.6
TNNL peer 3.3.3.1 (6s) VC Label 983053 R Label 1036 ,
PIM NBR 120.120.120.8
1/19 (16s)
PIM NBR 120.120.120.5
Flags: R-Router Port, V2|V3: IGMP Receiver, P_G|P_SG: PIM Join
1 (*, 225.1.1.1 ) 02:48:19 NumOIF: 1 profile: none
Mapped MAC Address: 0100.5e01.0101 FID: 0x008b
Outgoing Interfaces:
TNNL peer 3.3.3.1 ( P_G) 02:47:57/13s
Mapped group address 1: 225.1.1.1
1 (166.1.46.2, 225.1.1.1) in TNNL peer 2.2.2.1 02:48:19 NumOIF: 2 profile: none
Outgoing Interfaces:
TABLE 29 Output parameters of the show ip multicast vlan 18 command
Field Description
VLAN Shows the ID of the configured VLAN.
State Shows whether the VLAN interface is enabled or disabled.
Mode Shows whether the VLAN interface is in active mode or passive mode.
Active Querier Shows the active IGMP querier for the VLAN.
Time Query Shows the time countdown to generate the next query message.
(*, G)Count Shows the count of (*,G) entries.
(S, G)Count Shows the count of (S,G) entries.
Flags Shows the flags of the outgoing interface.
V2|V3 Shows the version of the IGMP message received.
P_G Indicates that a PIM (*,G) join was received on that interface.
P_SG Indicates that a PIM (S,G) join was received on that interface.
NumOIF Show the count of the outgoing interface.
profile Shows the profile ID associated with the stream.
Outgoing Interfaces Shows the list of outgoing interfaces.
FID Shows the FID resource allocated for a particular entry.
MVID Shows the MVID resource allocated for a particular entry.