Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 154)

142 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
IP multicast traffic reduction
1
To display only multicast MAC address information for Brocade NetIron CES and Brocade NetIron
CER devices, enter the following command at any level of the CLI.
NOTE
The show ip multicast vpls mac or show ip multicast vpls 10 mac commands are not supported
on Brocade MLX series and Brocade NetIron XMR devices.
Syntax: show ip multicast vpls vpls-id mac
You also can display PIM SM information by entering the following command at any level of the CLI.
Brocade(config)# show ip multicast vlan 2 pim
Number of PIM Groups:5
Total Number of PIM Entries: 5
vlan group port join-source age prune-source age
---- --------------- ----- ------------------- ---- ------------------- ----
2 229.0.0.5 1/1 2.1.1.100 180
2 229.0.0.4 1/1 2.1.1.100 180
2 229.0.0.3 1/1 2.1.1.100 180
2 229.0.0.2 1/1 2.1.1.100 180
2 229.0.0.1 1/1 2.1.1.100 180
Brocade(config)#
Syntax: show ip multicast vlan vlan-id pim
This display shows the following information.
show ip multicast pimsm-snoopings
Displaying IP multicast statistics
To display IP multicast statistics on a device, enter the following commands at any level of the CLI.
Brocade# show ip multicast vlan 1 statistics
IP multicast is enabled - Passive
VLAN ID 1
Reports Received: 34
Leaves Received: 21
General Queries Received: 60
This field... Displays...
VLAN The VLAN ID apply
Group The IP address of the multicast group.
Port The ports attached to the group’s receivers. A port is listed here when it
receives a join message for the group, an IGMP membership report for
the group, or both.
Join-source: IP address from which a join message was received.
age The join-source age.
Prune-source: IP address for pruning a source.
age The prune-source age.