Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 199)

Multi-Service IronWare Multicast Configuration Guide 187
53-1003032-02
Multicast Listener Discovery and source-specific multicast protocols
2
Syntax: show ipv6 mld [vrf vrf-name] group
The vrf parameter allows you to display the list of IPv6 MLD groups for the VRF instance identified
by the vrf-name variable.
Table displays the output from the show ipv6 mld group command.
Displaying MLD definitions for an interface
To display the MLD parameters on an interface, including the various timers, the current querying
router, and whether or not MLD is enabled, enter the following command.
TABLE 45 Output from the show ipv6 mld group command
Field Description
Interface port-number
has x groups This message shows the ID of the interface and how many multicast groups it
has.
# Index for the MLD group.
group IPv6 address of the multicast group.
phy-port The physical port to which the group belongs.
static Indicates if the group is a static group or not.
querier Indicates if the multicast group is a querier or not.
life The number of seconds the interface can remain in its current mode.
mode Indicates if the filter mode of the multicast group is in INCLUDE or EXCLUDE.
Brocade #show ipv6 mld group
Interface e6/18 has 11 groups
group phy-port static querier life mode
1 ff33::6:b:1 e6/18 no yes 0 incl
2 ff33::6:a:1 e6/18 no yes 0 incl
3 ff33::6:9:1 e6/18 no yes 0 incl
4 ff33::6:8:1 e6/18 no yes 0 incl
5 ff33::6:7:1 e6/18 no yes 0 incl
6 ff33::6:6:1 e6/18 no yes 0 incl
7 ff33::6:5:1 e6/18 no yes 0 incl
8 ff33::6:4:1 e6/18 no yes 0 incl
9 ff33::6:3:1 e6/18 no yes 0 incl
10 ff33::6:2:1 e6/18 no yes 0 incl
11 ff33::6:1:1 e6/18 no yes 0 incl