Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 66)

54 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
Displaying a list of multicast groups
To display PIM group information, enter the following command at any CLI level.
Brocade(config)# show ip pim group
Total number of groups for VRF default-vrf: 7
1 Group 226.0.34.0
Group member at e2/9: v59
Group member at e1/16: v57
2 Group 226.0.77.0
Group member at e2/9: v59
Group member at e1/16: v57
3 Group 226.0.120.0
Group member at e2/9: v59
Group member at e1/16: v57
4 Group 226.0.163.0
Group member at e2/9: v59
Group member at e1/16: v57
5 Group 226.0.206.0
Group member at e2/9: v59
Group member at e1/16: v57
6 Group 226.0.249.0
Group member at e2/9: v59
Group member at e1/16: v57
7 Group 226.0.30.0
Group member at e2/9: v59
Group member at e1/16: v57
Brocade(config)#
Syntax: show ip pim [vrf vrf-name] group
The vrf option allows you to display PIM group information for the VRF instance identified by the
vrf-name variable.
Table 9 describes the output from this command.
TTL Threshold Following the TTL threshold value, the interface state is listed. The
interface state can be one of the following:
•
Disabled
•
Enabled
Local Address Indicates the IP address configured on the port or virtual interface.
Mode
Version
Designated Router
TABLE 9 Output from the show ip pim vrf group command
This field... Displays...
Total number of Groups Lists the total number of IP multicast groups the device is forwarding.
NOTE: This list can include groups that are not PIM Sparse groups. If interfaces on
the device are configured for regular PIM (dense mode) or DVMRP, these
groups are listed too.
Index The index number of the table entry in the display.
TABLE 8 Output of the show ip pim sparse command (Continued)
This field... Displays...