Displaying the rp set list – Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) User Manual
Page 183
Multi-Service IronWare Multicast Configuration Guide
171
53-1003032-02
IPv6 PIM Sparse
2
The vrf parameter allows you to display RP information for a PIM Sparse group for the VRF instance
identified by the vrf-name variable.
The group-addr parameter is the address of an IPv6 PIM Sparse IP multicast group.
displays the output from the show ipv6 pim rp-hash group-addr command.
Displaying the RP set list
To display the RP set list, enter the show ipv6 pim rp-set command at any CLI level.
Syntax: show ipv6 pim [vrf vrf-name] rp-set
The vrf parameter allows you to display the RP set for the VRF instance identified by the vrf-name
variable.
displays the output from the show ipv6 pim rp-set command.
TABLE 37
Output from the show ipv6 pin rp-hash group-addr command
Field
Description
RP
Indicates the IPv6 address of the Rendezvous Point (RP) for the specified IPv6 PIM Sparse group.
Following the IPv6 address is the port or virtual interface through which this device learned the
identity of the RP.
Info source
Indicates the IPv6 address on which the RP information was received. Following the IPv6 address
is the method through which this device learned the identity of the RP.
TABLE 38
Output from the show ipv6 pim rp-set command
Field
Description
Number of group prefixes
The number of IPv6 PIM Sparse group prefixes for which the RP is responsible.
Group prefix
Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
RPs expected or received
Indicates how many RPs were expected and received in the latest Bootstrap
message.
RP num
Indicates the RP number. If there are multiple RPs in the IPv6 PIM Sparse
domain, a line of information for each of them is listed, and they are numbered
in ascending numerical order.
priority
The RP priority of the candidate RP. During the election process, the candidate
RP with the highest priority is elected as the RP.
age
The age (in seconds) of this RP-set.
NOTE: If this device is not a BSR, this field contains zero. Only the BSR ages
the RP-set.
Brocade# show ipv6 pim rp-set
Static RP
---------
Static RP count: 1
100::1
Number of group prefixes Learnt from BSR: 0
No RP-Set present