Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 153)

Multi-Service IronWare Multicast Configuration Guide 141
53-1003032-02
IP multicast traffic reduction
1
TNNL peer 3.3.3.1 VC Label 983053 R Label 1036 Port e1/31 ( P_G) 02:47:57/0s
e1/19 vlan 12 ( P_SG) 02:48:19/0s
FID: 0x008c MVID: 0
Syntax: show ip multicast vpls vpls-id
The vpls-id variable is the ID of a VPLS instance.
Table 30 describes the output parameters of the show ip multicast vpls command.
Syntax: show ip multicast vpls vpls-id
NOTE
The italicized text in the output of the command show ip multicast vpls vpls-id indicates multicast
MAC address information and is displayed only in the output for Brocade NetIron CES and Brocade
NetIron CER devices. Multicast MAC address information is not displayed in the output of Brocade
MLX series and Brocade NetIron XMR devices.
TABLE 30 Output parameters of the show ip multicast vpls command
Field Description
VPLS Shows the ID of the configured VPLS.
State Shows whether the VPLS interface is enabled or disabled.
Mode Shows whether the VPLS interface is in active mode or passive mode.
Active Querier Shows the active IGMP querier for the VPLS.
Time Query Shows the time countdown to generate the next query message.
(S, G)Count Shows the count of (*,G) entries.
(*, G)Count Shows the count of (S,G) entries.
Router ports Shows the ports through which the multicast sources can be reached.
VC Label Shows the MPLS VC label.
R label Shows the MPLS remote label.
PIM NBR Shows the PIM neighbor port.
Flags Shows the interface flag for the entry.
V2|V3 Shows the version of the IGMP message received.
P_G Indicates that a PIM (*,G) join was received on that interface.
P_SG Indicates that a PIM (S,G) join was received on that interface.
Mapped MAC Address Shows the multicast MAC address corresponding to the group.
NumOIF Show the count of the outgoing interfaces.
profile Shows the profile ID associated with the stream.
Outgoing Interfaces Shows the list of the outgoing interface.
FID Shows the FID resource allocated for a particular entry.
Mapped group address Shows the mapped group address.
MVID Shows the MVID resource allocated for a particular entry.
TNNL peer Shows the MPLS peer address.