Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 76)

64 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
Displaying the PIM multicast cache for FID
To display the PIM multicast cache for a specified fid, enter the following command at any CLI level
Brocade# show ip pim mcache fid 800e
Total entries in mcache: 17
1 (49.1.1.100, 229.0.0.1) in v49 (tag e4/9), Uptime 00:02:17 Rate 0
Sparse Mode, RPT=0 SPT=1 Reg=0 L2Reg=1 RegSupp=0 RegProbe=0 LSrc=1 LRcv=1
Source is directly connected. RP 192.168.1.1
num_oifs = 1
immediate_oifs = 0, inherited_oifs = 1, blocked_oifs = 0
52,4/12(00:02:17/0) Flags:00000004
fast ports ethe 4/12
L3 (HW) 1: e4/12(VL52)
Flags (0x7046c8e1)
fast ports ethe Shows the forwarding port ID.
L3 Show whether the traffic is switched or routed out of the interface.
(HW) Show whether the entry is software forwarded or hardware forwarded.
sm Sets the flag to 1, if the Sparse Mode entry is enabled and 0, if the PIM dense mode
entry is enabled.
ssm Sets the flag to 1, if the SSM mode entry is enabled, or else sets the flag to 0.
hw Sets the flag to 1, if the candidate for hardware forwarding is enabled, or else sets the
flag to 0.
fast Sets the flag to 1, if the resources are allocated for hardware forwarding, or else sets
the flag to 0.
slow Sets the flag to 1, if the entry is not a candidate for hardware forwarding or the
resource allocation is failed, or else sets the flag to 0.
leaf Sets the flag to 1, if DVMRP is enabled, or else sets the flag to 0.
prun Sets the flag to 1, if PIM is enabled, or else sets the flag to 0.
tag Sets the flag to 1, if there is a need for allocating entries from the replication table, or
else sets the flag to 0.
needRte Sets the flag to 1, if there is no route to the source and RP is available, or else sets the
flag to 0.
msdp_adv Sets the flag to 1, if RP is responsible for the source and must be advertised to its
peers.
AgeSltMsk Shows the slot number on which Management Processor (MP) expects ingress traffic.
FID Shows the FID resource allocated for a particular entry.
MVID Shows the MVID resource allocated for a particular entry.
RegPkt Shows the number of PIM register packet received.
AvgRate Shows the average data traffic rate for the mcache entry.
profile Shows the profile ID associated with the stream.
Number of matching
entries Shows the number of mcache entry.
TABLE 17 Output parameters of the show ip pim mcache mvid 1 command (Continued)
Field Description