Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) User Manual
Page 78
66
Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
Syntax: show ip pim mcache fid fid-id
The fid-id variable allows you to display an entry that matches a specified fid.
RP
Show the IP address of the RP.
num_oifs
Show the count of the outgoing interfaces.
inherited_oifs
Show the PIM Sparse mode inherited outgoing interfaces.
blocked_oifs
Show the PIM Sparse mode blocked outgoing interfaces.
Flags
Show the flags associated with the forward entry.
fast ports ethe
Shows the forwarding port ID.
L3
Show whether the traffic is switched or routed out of the interface.
(HW)
Show whether the entry is software forwarded or hardware forwarded.
sm
Sets the flag to 1, if the Sparse Mode entry is enabled and 0, if the PIM dense mode
entry is enabled.
ssm
Sets the flag to 1, if the SSM mode entry is enabled, or else sets the flag to 0.
hw
Sets the flag to 1, if the candidate for hardware forwarding is enabled, or else sets the
flag to 0.
fast
Sets the flag to 1, if the resources are allocated for hardware forwarding, or else sets
the flag to 0.
slow
Sets the flag to 1, if the entry is not a candidate for hardware forwarding or the
resource allocation is failed, or else sets the flag to 0.
leaf
Sets the flag to 1, if DVMRP is enabled, or else sets the flag to 0.
prun
Sets the flag to 1, if PIM is enabled, or else sets the flag to 0.
tag
Sets the flag to 1, if there is a need for allocating entries from the replication table, or
else sets the flag to 0.
needRte
Sets the flag to 1, if there is no route to the source and RP is available, or else sets the
flag to 0.
msdp_adv
Sets the flag to 1, if RP is responsible for the source and must be advertised to its
peers.
AgeSltMsk
Shows the slot number on which MP expects ingress traffic.
FID
Shows the FID resource allocated for a particular entry.
MVID
Shows the MVID resource allocated for a particular entry.
RegPkt
Shows the number of PIM register packet received.
AvgRate
Shows the average data traffic rate for the mcache entry.
profile
Shows the profile ID associated with the stream.
Number of matching
entries
Shows the number of mcache entry.
TABLE 18
Output parameters of the show ip pim mcache fid 8 command (Continued)
Field
Description