Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 193)

Multi-Service IronWare Multicast Configuration Guide 181
53-1003032-02
PIM Anycast RP
2
NOTE
The PIM Anycast CLI applies to only PIM routers running RP. All deny statements in the
anycast_rp_set ACL are ignored.
The example shown in Figure 20 is a PIM Anycast-enabled network with three RPs and one PIM-FH
router connecting to its active source and local receiver. Loopback 2 in RP1, RP2, and RP3 each
have the same IP addresses 1001:1. Loopback 3 in RP1, RP2, and RP3 each have separate IP
address configured to communicate with their peers in the Anycast RP set.
FIGURE 20 Example of a PIM Anycast RP network
Displaying information for an IPv6 PIM Anycast RP interface
To display information for an IPv6 PIM Anycast RP interface, enter the show ipv6 pim anycast-rp
command.
Syntax: show ipv6 pim [vrf vrf-name] anycast-rp
The vrf parameter allows you to display information for an IPv6 Anycast RP interface for the VRF
instance identified by the vrf-name variable.
Table 44 describes the parameters of the show ipv6 pim anycast-rp command.
TABLE 44 Output from the show ipv6 pim anycast-rp command
Field Description
Number of Anycast RP Specifies the number of Anycast RP sets in the multicast domain.
Anycast RP Specifies a shared RP address used among multiple PIM routers.
ACL ID Specifies the ACL ID assigned.
ACL Name Specifies the name of the Anycast RP set.
ACL Filter Specifies the ACL filter state SET or UNSET.
Peer List Specifies host addresses that are permitted in the Anycast RP set.
Brocade(config)# show ipv6 pim anycast-rp
Number of Anycast RP: 1
Anycast RP: 1001::1
ACL ID: 200
ACL Name: my-anycast-rp-set
ACL Filter: SET
Peer List:
1:1:1::1
2:2:2::2
3:3:3::3