Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 128)

116 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
IGMP V3
1
The vrf parameter specifies that you want to display IGMP interface information for the VRF
specified by the vrf-name variable.
Enter ve and its number, or ethernet and its slot/port to display information for a specific virtual
routing interface, or ethernet interface.
The tunnel num parameter specifies a GRE tunnel interface that is being configured. The GRE
tunnel interface is enabled under the router PIM configuration.
Entering an address for group-address displays information for a specified group on the specified
interface.
The report shows the following information:
Displaying IGMP traffic status
To display the traffic status on each virtual routing interface, enter the following command.
Syntax: show ip igmp [vrf vrf-name] traffic
This field Displays
Intf The virtual interface on which IGMP is enabled.
Port The physical port on which IGMP is enabled.
Groups The number of groups that this interface or port has membership.
Version
Oper The IGMP version that is operating on the interface.
Cfg The IGMP version that is configured for this interface.
Querier Where the Querier resides:
The IP address of the router where the querier is located
or
Self – if the querier is on the same router as the intf or port.
Max response
oQrr Other Querier present timer.
GenQ General Query timer
V1Rtr Whether IGMPv1 is present on the intf or port.
V2Rtr Whether IGMPv2 is present on the intf or port.
Tracking Fast tracking status:
Enabled
or
Disabled
Brocade# show ip igmp traffic
Recv QryV2 QryV3 G-Qry GSQry MbrV2 MbrV3 Leave IsIN IsEX ToIN ToEX ALLOW BLK
v5 29 0 0 0 0 0 0 0 0 0 0 0 0
v18 15 0 0 0 0 30 0 60 0 0 0 0 0
v110 0 0 0 0 0 97 0 142 37 2 2 3 2
Send QryV1 QryV2 QryV3 G-Qry GSQry
v5 0 2 0 0 0
v18 0 0 30 30 0
v110 0 0 30 44 11