Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 48)

36 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
PIM Dense
1
TABLE 6 Output fields from the show ip pim mcache command
Field Description
Total entries in mcache Shows the total number of PIM mcache entries
MJ Membership Join
MI Membership Include
ME Membership Exclude - Legend for the mcache entry printed once per page, it
gives the explanation of each of the flags used in the entry.
BR Blocked RPT
BA Blocked Assert
BF Blocked Filter
BI Blocked IIF
Uptime Shows the software entry uptime. This field is displayed on both the MP and
the LP modules.
Rate Shows the total number of packets per second that have been forwarded using
the hardware programmed forwarding entry (the (S,G) entry programmed in
hardware or (*,G) entries if (*,G) based forwarding is enabled). The rate is
displayed for all entries when the fwd_fast flag is set on the MP module.
upstream neighbor Shows the upstream neighbor for the Source/RP based on the type of entry.
For (*,G) it shows the upstream neighbor towards the RP. For (S,G) entries it
shows the upstream neighbor towards the source.
Flags Flags Represent Entry flags in hex format in the braces. And indicates the
meaning of the flags set in abbreviated string whose explanations are as
below. Only shows the flags which are set.
SM - Shows If the entry is created by PIM Sparse Mode
DM - Shows If DM mode entry is enabled
SSM - Shows If the SSM mode entry is enabled
RPT - Shows If the entry is on the Rendezvous Point (RP)
SPT - Shows If the entry is on the source tree
LSRC - Shows If the source is in a directly-connected interface
LRcv - Shows If the receiver is directly connected to the router
REG - if the data registration is in progress
L2REG - if the source is directly connected to the router
REGSUPP - if the register suppression timer is running
RegProbe
HW - Shows If the candidate for hardware forwarding is enabled
FAST - Shows If the resources are allocated for hardware forwarding
TAG - Shows If there is a need for allocating entries from the replication table
MSDPADV - Shows If RP is responsible for the source and must be advertised
to its peers.
NEEDRTE - Shows If there is no route to the source and RP is available
LEAF - Shows If DVMRP is enabled
PRUNE - Shows If PIM DM Prune to upstream is required
RP Show the IP address of the RP.
fast ports Shows forwarding port mask.
AgeSltMsk Shows the slot number on which MP expects ingress traffic.
FID, MVID Shows the resources that are allocated for forwarding the entry.