Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 70)

58 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
The vrf option allows you to display RP information for the VRF instance identified by the vrf-name
variable.
The group-addr parameter is the address of a PIM Sparse IP multicast group.
Table 13 describes the output from this command.
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
Brocade(config)# show ip pim rp-set
Static RP
---------
Static RP count: 2
1.51.51.4
1.51.51.5
Number of group prefixes Learnt from BSR: 1
Group prefix = 224.0.0.0/4 # RPs: 2
RP 1: 1.51.51.1 priority=0 age=60 holdtime=150
RP 2: 1.51.51.3 priority=0 age=30 holdtime=150
Brocade(config)#
Syntax: show ip pim [vrf vrf-name] rp-set
The vrf option allows you to display the RP set list for the VRF instance identified by the vrf-name
variable.
Table 14 describes the output from this command.
TABLE 13 Output from the show ip pim command
This field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP) for the specified PIM Sparse
group, followed by the port or virtual interface through which this device learned the
identity of the RP.
Info source Indicates the IP address on which the RP information was received, followed by the IP
address through which this device learned the identity of the RP.
TABLE 14 Output from the show ip pim vrf rp-set command
This field... Displays...
Number of group prefixes The number of PIM Sparse group prefixes for which the RP is responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
RPs expected or received Indicates how many RPs were expected and received in the latest bootstrap
message.
RP num Indicates the RP number. If there are multiple RPs in the PIM Sparse domain, a
line of information for each RP is listed, in ascending numerical order.