IAI America RCM-101-USB - Manual (Page 132)

9. Setup
120
(1) The message “Load cell calibration executing…” (Fig. 9.12) appears and the calibration is
performed.
Fig. 9.12 Load Cell Calibration In-Progress Message
(2) When the calibration is complete, the message “The load cell calibration was completed”
(Figure 9.13) appears.
Fig. 9.13 Load Cell Calibration Completion Message
If the calibration was not successful, the message “It failed in the load cell calibration” (Fig.
9.14) appears. If this message appears, check the cable connection of the load cell, etc., and
then perform the calibration again.
Fig. 9.14 Load Cell Calibration Failure Message