IAI America RCM-101-USB - Manual (Page 129)

9. Setup
117
9.3 Time Setting
(Note) This setting is available only with SCON-CA, PCON-CA ERC3 PIO Converter, MSEP and MSCON
controllers (Version V8.03.00.00 or later, V9.01.00.00 or later for MSEP, V9.02.00.00 or later for
MSCON).
From the main menu, click Setting, point to Controller Setup, and then select Time setting. On the axis
selection window, select the target axis number. Refer to 4, “Axis Selection.”
If a warning message appears when setting the axis number, switch the controller and PC
software settings according to the message, and then click Setting, point to Controller Setup,
and select Time setting to repeat setting from the beginning.
Fig. 9.5 Warning Message
Fig. 9.6 Time setting Window
[1] Date setting area
Set the last two digits of the year (2010 o “10”), month, and day.
[2] Time setting area
Set the hours, minutes and seconds.
[2]
[5]
[1]
[4]
[3]