E-Mon Energy Software - Manual (Page 97)

Meter
E-Mon Energy User Manual 9-2 E-MON
Where do I enter the Meter Information?
The meter information can be entered in two places: from the Meter tab of the Database or the Meter tab of the
Access Group.
Both windows have the same information, except that the Access Group window is where you can
send the meter information to the recorder. The following illustration describes the Meter tab on the Database
Access window and Access location window.
Figure 9.1 - Database Access - Meter Tab
Panel Group/Field Description
Meter Panel Group
Device ID* Type in the meter ID (only if you’re adding a new meter manually). This field
is required.
Location No. This field is fixed and cannot be changed. This field will always display the
current Location number selected.
Group No. This field is fixed and cannot be changed. This field will always display the
current Group number selected.
Meter Name Panel Group
Name
Type in the meter name. This is an optional field; however, we suggest you
provide a meaningful name. By default, E-Mon Energy™ will assign group,
location, recorder ID, and meter number.
ID Type in an ID number.
S/N Type in the serial number.
Ver. Type in the version number.
Energy Type Panel Group
Energy Type This is a drop-down field. Select the type of energy (i.e., electric, gas, water).
Usage Type in the usage unit of measure (e.g., KWH, GAL).
Demand Type in the demand unit of measure (e.g., KW).
Meter Mult This field is populated based on the voltage measurement, sensor size, and sets
of sensors in parallel.
Pulse Factor This is a drop-down field. Select pulse factor (i.e. 1, 16, 32, or 64). Older-
generation E-Mon meters are normally 1, newer are 16, rare cases 32. For other
types of meters utilizing pulse output such as KYZ, this field should be 1.