E-Mon Energy Software User Manual
Page 141
Access Location
E-Mon Energy User Manual
14-4
E-MON
Flag Status Button
The Flag Status provides an alert in the E-Mon Energy™ software of a problem or power failure. The two
failures illustrated below indicate the date and time of the last failure. The Power Failure Status indicates that
the IDR has lost power at some point. To reset (clear) the flags, click on the Clear Flag button. For complete
instructions, see Error Flag section within this manual.
Figure 14.8 - Access Location Function – Flag Status
Columns
Description
Status
This column displays the condition of the device. If the condition
states “Bad” or “Timeout,” there is a possible error in reading the
device and there may be a hardware or communication issue. If the
condition is “ok,” the hardware is functioning normally.
Power Failure Status
This column displays the total number of Power Failures and the
date/time of the last occurrence, since it was last reset. In this
example, there were more than 15 power failures and the last time
occurred on 12/30 at 15:44.
Tamper Alarm
This column displays an active
the recorder. If the Tamper Alarm is not on, the column will display
O’Load (Over Load)
This column displays an overload flag when the meter has
excessive amperage (i.e. 200 amp load through the sensors on a 100
amp meter). When no problem exist the column display
Power
This column displays any general power/voltage errors with the
meter (i.e. low, noisy or unstable). Low = voltage drop below
nominal level, noisy = dirty power supply, harmonics) unstable =
fluctuating levels. When no problems exist, the column displays
MTR Reg
This column displays any malfunctions with the recorder real-time
clock (i.e.
IDR State
This column will display any problems that may exist with the
functionality of the IDR. When no problems exist, the column
displays