E-Mon Energy Software - Manual (Page 210)

Status Bar Function Codes and Error Flag Codes
E-Mon Energy User Manual B-3 E-MON
command to modem.
13 3 Modem Dialing… Modem is dialing the destination phone
number.
14 3 Hanging Up… Wait while the modem is hanging up.
15 3 Not Connected
Refer to status bar panel 0 for the cause.
16 3 ONLINE Connection is established, ready to transmit
data.
17 3 Modem Busy The dialed number is busy.
18 3 NoCarrier Failed to establish connection, possible cause:
the dialed number is answered by voice.
19 3 No Carrier Can be generated if connection handshaking
began but was aborted, if the modem timed
out internally, or if a connection was
established and subsequently lost.
20 3 No Dial Tone No dial tone when a dial attempt began, may
indicate a cabling problem.
21 3 Connect failed: A connection attempt fails for any reason (i.e.,
busy signal, handshaking error).
22 3 Dial Canceled/Standby Modem dial canceled and is ready to make
connection.
23 3 STANDBY Ready to make the connection.
24 3 Hangup/Standby Modem hung up and is ready to make
connection.
25 3 Modem Cmd Error Modem return error occurred when sending
command to it (Modem Configuration or
Hardware Error).
26 3 Modem Init Error Modem return error occurred when sending
init string to it.
27 3 Dial Error Error in dialing the number, possible cause:
invalid phone number.
28 3 DialCancel Error Failed to cancel the Modem dialing.
29 3 Hangup Error Modem return error when hang-up occurs.
30 3 DialCmd Timeout Modem timeout when dialing.
31 3 DialCancelCmd Timeout Modem timeout when canceling the dial.
32 3 HangupCmd Timeout Modem timeout when hang-up occurs.
33 3 Modem is Connected Online Output data can now be transmitted.
34 3 Offlin e No transmission.
TCP Functions
No Status Loc Status Code Description
1 0 Bad data Data is Corrupted.
2 0 Unexpected data Data Received has wrong Check Sum.
1 3 Connecting… Wait, making connection.
3 3 Di sconnecting Wait, disconnecting.
4 3 ONLINE Connection is established, ready to transmit
data.
5 3 STANDBY Ready to make the connection.
6 3 Err or…Code (Example: Error…Code:10004) See TCP/IP
Connection Error Codes within this section.