E-Mon Energy Software User Manual
Page 88
Recorder
E-Mon Energy User Manual
8-11
E-MON
Scanning Recorder
To scan Recorder and Meter Devices:
3
From the Function group box, click on Setup Hardware.
4
From the Hardware to Access group box, click on All Possible.
Figure 8.16 - Scan Recorder and Status Window
1. Click on the S
CAN
R
ECORDER
button. By default, E-Mon Energy™ will start scanning
for any new devices starting with IDs of 1A, 1B….. Once the new devices are detected,
the grid will display the Recorder ID and the Meter Channel Status (OK, New, Bad….).
Updating the Database
To update the Database:
5
After the Scan Recorder process, wait until E-Mon Energy scans and moves past the last
installed device ID. Wait a few seconds and click C
ANCEL
. At this point, it will allow you
to update the database.
Figure 8.17 - Access Window Update Database
6
Click on the
U
PDATE
D
ATABASE
button. A dialog box displays with 4 list boxes New
Device
, Add to DB, Bad Device, and Delete from DB.
Note: The “New Device” list box displays all new devices detected during the scan.
Function Buttons
Update Database Button