E-Mon Energy Software - Manual (Page 133)

Other Features
E-Mon Energy User Manual 13-2 E-MON
Low Set Point Type in the Low Set Point value.
Set point using pulse count Check this box if the set point unit of measure is in raw pulses.
Ramp Select or enter the seconds waited until the load control will begin
checking the threshold set points.
Instantaneous one second
reading
Check this box if you prefer to have an instant one second reading
without the ramp.
Alarm Mode Panel Group
Hold Mode Check this radio button if you want the alarm to be held for a period
of time, once activated. This option prevents the alarm from short
cycling in a fluctuated load type.
Hold Period after Ramp Type in or select the seconds for the hold period after the ramp.
Grace Mode Check this radio button if you want the alarm to add a grace holding
period before the system will call-in.
Grace Period before Call-in Type in or select the seconds for the grace period.
Activate Relay
Check this box if you want the relay to be controlled by the alarm.
Call in when alarm
activated
Check this box if you want the recorder to call home when the
alarm is activated.
Call in at End of Interval Check this box if you want the recorder to call home at the end of
the interval when the alarm is activated.
Call in Retries Select the number of retries to call-in.
Maximum Call/Days Select how many times you want the recorder to call home on alarm
basis. Enter 0 to disable.
* = Required field.