Burkert Type 8645 - Manual (Page 44)

44 - 8645
ConfiGuraTion anD funCTion of The moDules
English
Operating� and display Elements
Rotary Encoder Switch - Address and Baud rate
(x10) (x1) baud rate
Location: The rotary encoder switch is located in the lower part
of the CANopen fieldbus module (see illlustration
Rotary encoder
switch).
Address setting: Address 1 0 (x10) + 1 (x1)
: : :
Address 99 9 (x10) + 9 (x1)
baud rate:
Value baud rate Value Baud rate
0 1 Mbaud 4 125 kbaud
1 800 kbaud 5 100 kbaud
2 500 kbaud 6 50 kbaud
250 kbaud 7 20 kbaud
Illustration: Rotary encoder switch
LEd Status displays
BUS_OK (BO)
FAILURE_SELECT (FS)
U_LOGIC_OK (U
l
)
U_SENSOR_OK (U
S
)
BUS_FAULT (BF)
FAILURE_NUMBER (FN)
U_DRIVER_OK (U
O
)
Display during nor-
mal operation
BUS (BO)
BUS (BF)
FS
FN
U
o
U
i
U
S
ON
OFF
OFF
OFF
ON
ON
ON
Illustration: Allocation of the LEDs on the Fieldbus module CANopen
LED Status Displays
Abbreviation color Meaning Explanation
BO green Bus OK see table CANopen RUN LED
BF red Bus FAULT see table CANopen ERROR LED
FS yellow FAILURE
SELECT Defines the function of the LED FN:
FS lit: FN indicates the type of failure
FS not lit: FN indicates the failure number
FN red FAILURE
NUMBER The number of flashing pulses indicates the failure type or failure
number, depending on the setting of FS.
U
i
green U Logic OK Voltage for logic supply,
Inputs and bus interface provided.
U
O
green U Driver OK Power supply for the outputs OK.
U
S
green U Driver OK Separate display of the voltage for the inputs.