Burkert Type 8645 - Manual (Page 154)

154 - 8645
CommissioninG
English
Illustration: Class Instance Editor
Here, the actual module list can be projected into the desired module list using Explicit Message.
Choose Service Code Set Single Attribute (10).
Enter the value Class 96 (Hex) / Instance 1 / Attribute 5.
Enter either 1 (without bus diagnosis) or 2 (with bus diagnosis) under Data sent to the device.
Confirm with Execute.
This confirms that the data
has been recorded
Illustration: Class Instance Value 1
After the data has been entered, confirm that („The execution was completed”) and close the window.
Do a hub current reset.