Burkert Type 8645 - Manual (Page 156)

156 - 8645
CommissioninG
English
config�uration of the 1747 SdN Scanner Module
In order to communicate with the slave (Type 8645) DeviceNet must be configured as a master.
Open the properties of the 1747 SDN Scanner Module, either by double-clicking on the symbol or
right-clicking on the symbol and after that, choose the properties.
Choose Scanlist and upload the data.
Choose the Available Device Type 8645 and add it to the Scanlist.
Confirm the message that appears with OK.
Illustration: Scanlist
Push the Edit I/O parameter button. (The button is only active after the device has been accepted into
the Scanlist).
Enter the previously observed/noted values.
Illustration: Edit I/O Parameters