Rainbow Electronics MG260 - Manual (Page 98)

FLYFOT-MG260-MODULE
Page: 98 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
AT+CLIP?
Note: ask for current value CLIP “+CLIP: 0,1
OK
AT+CLIP =1
Note: activate CLIP OK
RING
+CLIP: “01062965555”, 129
Note: if the CLIP function is active, for an
incoming call, after each RING indication the
CLIP indication will be come.
Defined values:
: parameter sets/shows the result code presentation in the follows
0: Disable
1: Enable
: parameter shows the subscriber CLIP service status in the network
0: CLIP not provisioned
1: CLIP provisioned
2: Unknown (no network…)
10.7 Connected line identification presentation +COLP
Description:
This command allows control of the connected line identification presentation supplementary service -
useful for call forwarding of the connected line.
Syntax :
Command syntax: AT+COLP=
Response syntax:
+COLP: , (as response to AT+COLP?)
+COLP: , [ ,, , ]
after ATD command, before OK or CONNECT
Command
Possible responses
AT+COLP=0
Note: deactivate COLP OK
AT+ COLP?
Note: ask for current value COLP +COLP: 0,2
OK
AT+ COLP =1
Note: activate COLP OK
ATD1860; +COLP: “1860”, 129