Rainbow Electronics MG260 - Manual (Page 130)

FLYFOT-MG260-MODULE
Page: 130 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
13.6 Quality of Service Profile (Minimum acceptable) +CGQMIN
Description
This command allows the TE to specify a minimum acceptable profile which is checked by the MT
against the negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the local context identification parameter,
. Since this is the same parameter that is used in the +CGDCONT command, the +CGQMIN
command is an extension to the +CGDCONT command. The QoS profile consists of a number of
parameters, each of which may be set to a separate value.
A special form of the set command, +CGQMIN= causes the minimum acceptable profile for context
number to become undefined. In this case no check is made against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types,
the parameter value ranges for each PDP type are returned on a separate line.
Syntax
Command Possible Response(s)
AT+CGQMIN=[ OK
[, [, ERROR
[, [,
[,]]]]]]
AT+CGQMIN? +CGQMIN: , , ,
, , [+CGQMIN:
, , , , ,
[…]]
OK
AT+CGQMIN=? +CGQMIN: , (list of supported
s), (list of supported s), (list of
supported s) , (list of supported s), (list
of supported
s) [+CGQMIN: , (list of
supported s), (list of supported
s), (list of supported s) , (list of
supported s), (list of supported s)
[…]]
OK
AT +CGQMIN=1,1,4,5,2,31 OK