Rainbow Electronics MG260 User Manual
Page 174
FLYFOT-MG260-MODULE
Page: 174 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18.3 Mobile Equipment event reporting +CMER
Description :
This command enables or disables sending of unsolicited result codes in the case of a key press.
Syntax :
Command Syntax: AT+CMER=
Response syntax (key press event report) : +CKEV :
Response syntax (indicator event report) : +CIEV:
Command
Possible responses
AT+CMER=,1
Note : Ask key press event report
OK
+CKEV:12,1
+CKEV:12,0
Note : Key 12 has been pressed and
released.
AT+CMER?
+CMER: 3,1,0,0,0
OK
Defined values :
Important note : The parameters
0 : No keypad event reporting.
1 : Keypad event reporting are routed using unsolicited code. Only the key pressings not caused by
+CKPD are indicated.
2 : Keypad event reporting are routed using unsolicited code. All key pressings are indicated.
Note: As AT software does not manage the emulation of key press, the values 1 and 2 lead to the same
results.
0 : no indicator event reporting
1 : indicator event reporting using unsolicited result code. Only the indicator events not caused by +CIND
shall be indicated by the TA to the TE
2: indicator event reporting using unsolicited result code. All indicator events shall be directed from
TA to TE