Rainbow Electronics MG260 - Manual (Page 177)

FLYFOT-MG260-MODULE
Page: 177 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18.5 Mobile equipment control mode +CMEC
Description :
This command selects the equipment which operates ME keypad, writes to ME display and sets ME
indicators. If operation mode is not allowed by the ME, +CME ERROR: is returned
Syntax :
Command Syntax: AT+CMEC=[[,[,]]]
Response syntax : +CMEC: ,,
Command
Possible responses
AT+CMEC=[[,[,]]] +CME ERROR:
AT+CMEC=[[,[,]]] OK
AT+CMEC?
+CMEC: 2,0,0
OK
AT+CMEC=? +CMEC: (2),(0),(0)
OK
Note: no change allowed
Defined values:
:
0 : ME can be operated only through its keypad (execute command of +CKPD cannot be used)
1 : ME can be operated only from TE (with command +CKPD)
2 : ME can be operated from both ME keypad and TE
:
0 : only ME can write to its display (command +CDIS can only be used to read the display)
1 : only TE can write to ME display (with command +CDIS)
2 : ME display can be written by both ME and TE
:
0 : only ME can set the status of its indicators (command +CIND can only be used to read the indicators)
1 : only TE can set the status of ME indicators (with command +CIND)
2 : ME indicators can be set by both ME and TE
18.6 Read Language Preference +WLPR
Description :
Read a Language Preference value of EF-LP. The first indices should have the highest priority.